At a glance

The shop floor everyday machine.

The OMSES 030 is a 1.5 kW system with inbuilt booster for shops running production CNCs on one or two shifts. It covers the same standard machining range as the 020 and 040, with output sized for heavier day-to-day use. Same standalone PLC, same touchscreen HMI, same Harting plug-and-play interface as every other ecosol.

Technical specifications

Full data sheet.

All values for OMSES 030 220V single-phase configuration.

Electrical

Supply voltage

220V single-phase

Power rating

1.5 kW maximum

Controller

Standalone PLC with touchscreen HMI

CNC interface

10 pin CNC Harting interface + 24 pin MQL system connector

Pneumatic

MQL pressure

5–10 bar (varies with operation and aerosol tube length)

Maximum inlet pressure

≤ 10 bar

Air consumption

10–12 CFM at 4 barDepends on tool and application

Air quality

ISO 8573-1:2010, quality class 5 or better

Air inlet

10 mm connection

Aerosol outlet

8 mm, 2 ports

Lubricant

Recommended oil

KwikKut® OMSecolube 99more than 99% vegetable-based ester oil

Tank capacity

5 litresApproximately 3 days of 20-hour cycle operation

Topup frequency

1.5–2 litres per day under typical load

Physical

Dimensions (H × W × D)

approx. 1200 × 410 × 385 mm (with tank)

Installation orientation

Vertical, mounted on machine back panel

Ambient temperature

+5 °C to +50 °C

Empty weight

Approximately 70 kg

Origin

100% Made in India, Pune, Maharashtra

In the box

What you get with every OMSES 030.

Every ecosol ships ready to install. No additional control hardware or software required.

Closed-loop aerosol generator with booster
Touchscreen HMI with regular cycle and manual modes
Standalone PLC, no integration with CNC controller needed
5-litre lubricant reservoir with low-level alarm
P1 and P2 pressure regulators with analogue gauges
Inlet regulator with digital pressure switch
VFD-controlled aerosol delivery
Harting CNC interface, plug and play with any machine
Manual cycle start/stop pushbuttons + alarm reset
Installation and operating manual

Applications

Built for production volume.

The OMSES 030 handles the full standard machining range, comfortably, across long shifts.

Milling & Drilling

Face milling, end milling, deep-hole drilling on common steels, cast iron, aluminium. Handles higher spindle speeds than the 020.

Tapping & Broaching

Through-spindle aerosol extends tap life significantly. Consistent lubrication across long production runs without coolant tank top-ups.

Turning & Bar Saw Cutting

Open-cast delivery for lathe turning and bar saw operations. Dry, corrosion-free chips. No rust preventives needed on finished parts.

Or any other cutting operation.

Compatible lubricant

Recommended KwikKut® OMSecolube lubricant.

Use of an unapproved lubricant may cause performance issues or damage for which Ogale is not responsible, and may void warranty coverage.

KwikKut® OMSecolube 99

More than 99% vegetable-based ester MQL oil. Formulated to be non-hazardous and biodegradable based on ingredient data. HMIS health rating 0. Available in 35 Litre packs.

Lubricant specifications →

Compare